● Please follow all 『Safety Precautions』 to avoid fire、 electric shock and otherrelated injuries.● After reading the manual, please ensureto store it
Input the new set value of the measurement jig.It is possible to store up up to 10 types of measurement conditions.Input new set values to a program.
Press for more 2 seconds Setting the measured value display unit.Select「 Shift unit 」 then SET.Display will change to as belowIf in μm, select「 1.μm
Setting work lower tolerance limit value.Setting the language.Select「 OK/-NG 」 then SET.Select「Language」 then SET.Input lower tolerance limit value. S
Turn the ZERO adj knob full to theright then turn it to the left 2.5 times.Adjust CAG measurement standard pressure.ZERO adj. knobPress for more
Adjusts the ZERO and MAG Set min master on the measurement jig. position of the measurement Adjust 「ZERO 」 so the indicator jig and CAG. is close to
Set 「Max Master」 on measurement jig.After the indicators stabilizes, press .Calibration of the min master 「Max Master」 is performed.and max master.
It is possible to output the measured data(value and judgement) to the RS232C. ! Caution While the mode display is ,● If mastering is NG, it is
Calibration of masters with the use of external switch.If the device is connected with external push button or foot switch, the following operations a
Page No 設定項目名 Label设定项目名称1 極性Polarity极性 □ 1 . +□ 2 . -2 測定レンジ Range选择量程□ 1 . μm□ 2 . μm□ 3 . μm3 シフト単位 Shift Unit公差中间单位□ 1 . μm□ 2 . mm4 シフト値 Shift Va
7 . Do not use damaged cables or plugs. Damaged cables or plugs are possible Before using this device, make sure you causes of fire and electric sho
Product nameModelBasic SpecificationsNo. of channelsMeasurement itemsMeasurement range[μm] Preset prior to shipment.Display range [μm]Depends on the p
- -Option: Peak measurement function: Rank display functionOrifice diameter & BoardDepending on a connected probe spec,orifice dia and board conf
① BAR LEDDisplays the meas. value② LCD displayDisplays the meas. value, judgement result and set values.③ Panel switch for masteringUsed to change mod
⑫ Mode display ⑮Measured valueDisplays the current mode and condition.Measurement mode ⑯ Unit displaySet mode⑰ Value displayDisplays the measured Cali
● Install the device on a stable Plug the AC adaptor to the power and level surface with no source.vibrations.Set the device on the desired place. T
Perform calibration by master.● Mastering must be done on any of the following conditions.●Air micrometer is a comparative ・ Every 2 to 4 hoursmeasuri
Measure the work object. Hold the measured value and output ! Caution it to RS232C.● During measurement mode, ! CautionBy pressing for more th
Comments to this Manuals